one engine conversion starting to unfold
i dont know what year model but seems all good
| ausmini https://www.ausmini.com/forums/ |
|
| she arrived https://www.ausmini.com/forums/viewtopic.php?f=23&t=17621 |
Page 1 of 1 |
| Author: | mini_matt [ Mon Mar 27, 2006 9:46 pm ] |
| Post subject: | she arrived |
one engine conversion starting to unfold
i dont know what year model but seems all good |
|
| Author: | DTrain [ Mon Mar 27, 2006 11:13 pm ] |
| Post subject: | |
check the plate |
|
| Author: | 13secmini [ Tue Mar 28, 2006 6:16 am ] |
| Post subject: | |
that is a 91-92 model with the digital boost display rather then the later 93-96 models that had a needle gauge for boost. |
|
| Author: | pulver [ Tue Mar 28, 2006 8:20 pm ] |
| Post subject: | |
So did you get it started? or were you just turning it over? Cheers |
|
| Author: | mini_matt [ Wed Mar 29, 2006 7:23 am ] |
| Post subject: | front cut |
turned it over first to see if oil pressure would be a issue, then we started for a sec on aerostart. today gunna run it of the falcon fuel pump |
|
| Author: | cush [ Wed Mar 29, 2006 7:26 am ] |
| Post subject: | |
the starlet boys must be getting pissed off that we keep tkaing their engines.. 
|
|
| Author: | JC [ Wed Mar 29, 2006 7:57 am ] |
| Post subject: | |
Not really. We are providing a whole new parts division for them with front cut left overs. |
|
| Author: | minimetoy [ Wed Mar 29, 2006 8:21 pm ] |
| Post subject: | |
Thumbs up. You'll find you can off load many of the parts on the starlet forum. Dan |
|
| Author: | mini_matt [ Thu Mar 30, 2006 9:36 am ] |
| Post subject: | |
she runs beautifully ran her last night now to dismantle her |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|