| ausmini https://www.ausmini.com/forums/ |
|
| NSW Engineer https://www.ausmini.com/forums/viewtopic.php?f=23&t=17723 |
Page 1 of 1 |
| Author: | minimetoy [ Thu Mar 30, 2006 9:10 pm ] |
| Post subject: | NSW Engineer |
Guys, Need info about engineer's for the conversion. When i started i rang an engineer and spoke to him about what i wanted to do and he confirmed it was OK he also gave me fixed prices of $100/ hr and $350 for final certificate. Anyway to cut a long story he seems to have fallen of the edge of the world, phone does not work and no new listing in the phone book. Anyway i started ringing around and got one guy telling me $1500 (seemed to pluck the no out of thin air) and another guy was almost as bad a Matt's inspector (probably related to the act inspector) need a cat convertor, collapsable column etc etc. So who has used what engineer and how much has it cost?? I am at the stage wher i want to strip the engine bay out to respray and clean the motor and re-assemble. Dan |
|
| Author: | minstar [ Thu Mar 30, 2006 9:34 pm ] |
| Post subject: | |
Dan I think I must have given you the wrong idea about my engineer, he actually said I didn't need a cat and basically didn't really tie me down to much really. As engineers go he was pretty open minded...I'd recommend him... Actually I just reread your post the above doesn't make alot of sense sorry... 
Cheers Matt |
|
| Author: | Baracade [ Fri Mar 31, 2006 11:06 am ] |
| Post subject: | |
I can get you two names... I'll call you this arvo... If you havent heard from me by dinner give me a buzz.. Cheers |
|
| Author: | minimetoy [ Sun Apr 02, 2006 9:23 am ] |
| Post subject: | |
Dean, Can you Pm me your No and I'll give you a buzz tomorrow. Thanks Dan |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|