| ausmini https://www.ausmini.com/forums/ |
|
| DRIVE SHAFTS https://www.ausmini.com/forums/viewtopic.php?f=23&t=21346 |
Page 1 of 1 |
| Author: | minimetoy [ Thu Aug 10, 2006 8:38 pm ] |
| Post subject: | DRIVE SHAFTS |
Its time to get my shafts made. Who can i use? Gzevan, the guy who did yours, is he situated in bankstown? and if so do you think he would do a house call? Who was he? Dan |
|
| Author: | gzeVan [ Thu Aug 10, 2006 9:46 pm ] |
| Post subject: | |
hey Dan I used a company called AGM Engineering at Pullman pl Emu plains, Mini_man ,16vminivan also used them and we are all happy with the results i can pull out there number if you wish ,he just requires inner and outer CV samples and measurments cheers Paul |
|
| Author: | minimetoy [ Fri Aug 11, 2006 4:15 pm ] |
| Post subject: | |
Paul, Number would be good. Cheers Daniel |
|
| Author: | Mini Mad [ Fri Aug 11, 2006 5:05 pm ] |
| Post subject: | |
Dan, i need some too..let me know how you go..might be able to get them together, maybe cheaper? |
|
| Author: | gzeVan [ Fri Aug 11, 2006 8:08 pm ] |
| Post subject: | |
AGM Engineering 9 Pullman pl Emu Plains 2750 (02) 47357214 ask for Anthony its not to hard to find take russell st exit off M4 |
|
| Author: | Mini Mad [ Fri Aug 11, 2006 9:49 pm ] |
| Post subject: | |
How long was the turnaround? |
|
| Author: | minimetoy [ Sat Aug 12, 2006 5:43 pm ] |
| Post subject: | |
Cheers Paul. Josh, sounds like a good idea. Dan |
|
| Author: | gzeVan [ Sun Aug 13, 2006 9:08 am ] |
| Post subject: | |
guy's took a couple of weeks ,he had a few big jobs on at the time. i still had other things to do in between so it wasnt to bad cheers Paul |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|