| ausmini https://www.ausmini.com/forums/ |
|
| Hi/Lo boost button https://www.ausmini.com/forums/viewtopic.php?f=23&t=24735 |
Page 1 of 1 |
| Author: | minimetoy [ Fri Nov 10, 2006 7:34 pm ] |
| Post subject: | Hi/Lo boost button |
Guys, Can someone tell me what colour wires go into the back of the dash mounted hi/lo boost switch on the ep82. Does any one know if it is an open circuit or closed? Need to figure out how to wir it up. Thanks Dan |
|
| Author: | madmorrie [ Sun Nov 12, 2006 10:10 pm ] |
| Post subject: | |
Hey Dan Took some pics of my loom and played with a multimeter across the pins of the plug. Seems to close the circuit between the two outer pins when pressed. The centre pin did not connect to the other pins either up or down. Only two wires though so I say its a redundant pin. Wires are a brown and a green with brown (or maybe red) trace. Hope this helps Madmorrie 
|
|
| Author: | minimetoy [ Mon Nov 13, 2006 7:33 am ] |
| Post subject: | |
Your a legend Madmorrie. Thanks a lot. I'll have a look tonight. Dan |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|