Ausmini
It is currently Fri Dec 13, 2024 7:59 pm

All times are UTC + 10 hours




Forum locked This topic is locked, you cannot edit posts or make further replies.  [ 1 post ] 
Author Message
PostPosted: Sat Jun 27, 2020 8:58 am 
Offline
religious status
religious status
User avatar

Joined: Fri Mar 19, 2004 6:19 pm
Posts: 39701
Location: near Baulkham Hills, NSW
Maximum clamping force is achieved when the conical diaphragm spring is flat.
With new original parts this was so. However after 50 years of wear, flywheel refacing, and backplate refacing, this is seldom achieved. Unless you get a clutch shop familiar with Minis to set it up. Or do the following:

The 3 backplate lugs need refacing so that the spring is flat when assembled with the drive straps, backplate, and a new clutch driven plate.
To check this, after assembly on the bench I hold a 3mm drill against the spring. If spring is flat the drill will be parallel to the flywheel face.
If not, I remove 3 straps and assemble again and check spring.
Each strap is .035" thick. So I can guesstimate how much needs to be machined from the 3 lugs to make spring flat with 6 straps in.
Take all 6 straps out to check if needed.
I have seen 2 clutches that needed .070" off the lugs!!
I set the backplate flat on the mill and mill the lugs equally. I have a digital display on the spindle axis for height.
Do not set the spring beyond flat!! A little less is fine.

Engine builders with a hydraulic press (like GR) measure the amount to remove by using a dial gauge to measure how far the diaphragm is pressed down to get the spring flat.
I don't have a press!

_________________
DrMini- 1970 wasaMatic 1360, Mk1S crank, 86.6HP (ATW) =~125 @ crank, 45 Dellorto (38 chokes), RE282 sprint cam, 1.5 rockers, 11.0:1 C/R. :mrgreen:


Top
 Profile  
 
Display posts from previous:  Sort by  
Forum locked This topic is locked, you cannot edit posts or make further replies.  [ 1 post ] 

All times are UTC + 10 hours


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  

© 2016 Ausmini. All garage work involves equal measures of enthusiasm, ingenuity and a fair degree of irresponsibility.