ausmini https://www.ausmini.com/forums/ |
|
RE 13 Cam https://www.ausmini.com/forums/viewtopic.php?f=5&t=101622 |
Page 1 of 1 |
Author: | Minikman [ Sat Dec 10, 2022 8:34 am ] |
Post subject: | RE 13 Cam |
Good morning all. Chasing some info. I have a RE13 camshaft I obtained about 10 years ago. Now putting it to use in a 1275 build but lost the specs sheet necessary for dialing it in. Can anyone help? Thank you everyone for your amazing knowledge & helpful attitude. Cheers, Lindsay |
Author: | timmy201 [ Sat Dec 10, 2022 9:48 am ] |
Post subject: | Re: RE 13 Cam |
My RE cam had the tappet clearance and cam timing engraved on it, don’t suppose yours does too? |
Author: | winabbey [ Sat Dec 10, 2022 10:10 am ] |
Post subject: | Re: RE 13 Cam |
https://www.calverst.com/product-fittin ... ng-re13pp/ |
Author: | slide [ Sat Dec 10, 2022 10:56 am ] |
Post subject: | Re: RE 13 Cam |
I set mine up 2 degrees advanced, and valve clearance at .016" Great mid range torque. |
Author: | 9YaTaH [ Mon Dec 12, 2022 8:49 am ] |
Post subject: | Re: RE 13 Cam |
Minikman wrote: Good morning all. Chasing some info. I have a RE13 camshaft I obtained about 10 years ago. Now putting it to use in a 1275 build but lost the specs sheet necessary for dialing it in. Can anyone help? Thank you everyone for your amazing knowledge & helpful attitude. Cheers, Lindsay https://russellengineering.com.au/project-68mm-pt4/ |
Page 1 of 1 | All times are UTC + 10 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |