| ausmini https://www.ausmini.com/forums/ |
|
| Help: what size & thread bolts ?-------THANKYOU https://www.ausmini.com/forums/viewtopic.php?f=5&t=34229 |
Page 1 of 1 |
| Author: | russdog1 [ Thu Jul 26, 2007 7:46 pm ] |
| Post subject: | Help: what size & thread bolts ?-------THANKYOU |
New to mini's, can anybody tell me what thread size & pitch are the three bolts used with the flywheel puller on a A+ 1300 engine out of a 1989 Metro. Have tried 10mm X 1.25. did'nt start well & only went in about 1&1/2 threads & got tight. Tried 3/8 sae (unf) with the same result . I don't want to strip or damage the treads. Any one with the answer Thanks Russdog |
|
| Author: | drmini in aust [ Thu Jul 26, 2007 8:08 pm ] |
| Post subject: | |
I think I read somewhere that those (Verto flywheel setup) 3 holes are M10x 1.5. But I've never done one... |
|
| Author: | KLAS [ Thu Jul 26, 2007 9:23 pm ] |
| Post subject: | |
yes, it's M10x1.5 |
|
| Author: | russdog1 [ Thu Jul 26, 2007 9:32 pm ] |
| Post subject: | help: what size & thread |
Thanks for the reply's I'll try 10 mm X1.5 & let youknow if it works. Thanks Russdog |
|
| Author: | russdog1 [ Fri Jul 27, 2007 7:57 pm ] |
| Post subject: | |
Thanks for the reply's - spot on it's 10mm x1.5 |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|