| ausmini https://www.ausmini.com/forums/ |
|
| how hard is it to get registered? and get a s/c? https://www.ausmini.com/forums/viewtopic.php?f=5&t=3663 |
Page 1 of 1 |
| Author: | modified minis [ Mon Dec 27, 2004 2:10 pm ] |
| Post subject: | how hard is it to get registered? and get a s/c? |
hey everyone. i was wondering how hard is it to get a flip front registered in qld. if you have one on your mini and you are around the gold coast and brisbane area, were abouts did you get it done, and how much did it cost. was it hard to get it registered with it on..... thanx 
|
|
| Author: | Rising Star [ Tue Dec 28, 2004 9:59 am ] |
| Post subject: | |
should be legal with proper support you will need supports running from the front of the subframe to the top suspension tower to compensate for the bits u remove price depends on which way ur going cheapest is to keep metal front unpick along the seam (will prob have to cut some parts off) brace the subframe then put hinges on the front where the front can sit on more expensive way is go fibreglass front make mold of front of car, cut old front off make product out of mold, brace the subframe make product fit and line up properly depends on how handy u are metal one can normally be done for under $100 from what i've heard fibreglass ur looking more at the $1500 mark http://www.manchester-minis.cwc.net/tec ... front1.htm good example |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|