Quote:
fairly typical wear pattern that I find on strip down of a road engine equipped with 1.5:1 ratio rockers. Typically mileages from 10,000 to 50,000 depending on use and oil changes etc.
F*CK !!
| ausmini https://www.ausmini.com/forums/ |
|
| RE 13 cam specs https://www.ausmini.com/forums/viewtopic.php?f=5&t=45049 |
Page 1 of 1 |
| Author: | smelly [ Thu Aug 21, 2008 6:21 pm ] |
| Post subject: | RE 13 cam specs |
Has any one got all the details/specs on the RE13 cam shaft. And if posible info on dialing in this cam shaft. Cheers Tony. |
|
| Author: | drmini in aust [ Thu Aug 21, 2008 7:56 pm ] |
| Post subject: | |
RE13 is listed in here, scroll down... http://www.mlmotorsport.com/index.php?o ... topic=11.0 PM me for more info. |
|
| Author: | simon k [ Thu Aug 21, 2008 10:54 pm ] |
| Post subject: | |
Quote: fairly typical wear pattern that I find on strip down of a road engine equipped with 1.5:1 ratio rockers. Typically mileages from 10,000 to 50,000 depending on use and oil changes etc.
F*CK !! |
|
| Author: | sgc [ Thu Aug 21, 2008 10:57 pm ] |
| Post subject: | |
Holy cow! "Fairly typical"!? Yoinks! 
|
|
| Author: | drmini in aust [ Fri Aug 22, 2008 7:09 am ] |
| Post subject: | |
I had a VP3 Camtech cam that looked like that after 45,000 miles with 1.5 rockers. Valve lift on 2 valves dropped from .470" to .270". But many other lobes were still fine, go figure... 
I reckon it was a combination of the oil I was running, the pointy VP3 lobes, and the cam hardness or lack thereof. RE13 cam lobes have a nice big nose radius, from what I've seen they don't wear much, 1.5 rockers or not. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|