Who uses one?

I bought one of these kits:
http://www.minispares.com/Product.aspx?ty=ki&pid=35510&sku=0&tc=1#submenu

for my motor and am having some trouble getting it to fit, as the crank pulley is fouling the timing case. Am I missing something?

Thanks.

_________________
1970 Mini Deluxe - 1275, Weber, Clive 346 cam, MS 4-pot slotted discs, Megajolt ignition Now with new improved Mambas... almost on the road
1966 Van with Traveller rear seat conversion
2008 Prado GXL
All in various states of repair...

are the 2 pulleys lining up properly? are they pulling all the way in when you bolt them up?

the listing says
"On 1996(mpi) onwards minis the plastic cover will need to be modified to clear crank pulley"
your sig lists a '94spi, but maybe there was a common issue?

_________________
did I tell you that I won a trophy?

I run an early kit, and the harmonic balancer hub has been shortened about 1.5mm.

Does the bottom belt pulley have a separate steel outer flange like mine, or is it part of the pulley? If no flange there it may be missing. Then the balancer/crank pulley will be too far in.

<edit> is it the cam belt pulley fouling, or the harmonic balancer?

_________________
DrMini- 1970 wasaMatic 1360, Mk1S crank, 86.6HP (ATW) =~125 @ crank, 45 Dellorto (38 chokes), RE282 sprint cam, 1.5 rockers, 11.0:1 C/R.