Hey all looking at the cam listed in the for sale section
Question is is there different cams between 1275 and 1098 ?
Probably a silly question but one that had to be asked !
Cheers Jamie
| ausmini https://www.ausmini.com/forums/ |
|
| Cam question very noob! https://www.ausmini.com/forums/viewtopic.php?f=5&t=55673 |
Page 1 of 1 |
| Author: | mad-mk1 [ Sun Aug 02, 2009 3:17 am ] |
| Post subject: | Cam question very noob! |
Hey all looking at the cam listed in the for sale section Question is is there different cams between 1275 and 1098 ? Probably a silly question but one that had to be asked ! Cheers Jamie
|
|
| Author: | 92 [ Sun Aug 02, 2009 5:24 am ] |
| Post subject: | |
A 1275 cam can be fitted to a 1098 no worries Standard the small bore cams only have 3/8' wide lobes where as a 1275 has 1/2' wide lobes which are better. Any decent cam grinder will stamp the end of the cam to tell what the cam has been ground to. |
|
| Author: | meeni [ Sun Aug 02, 2009 7:40 pm ] |
| Post subject: | |
make sure the oil pump drive is the same.. |
|
| Author: | drmini in aust [ Sun Aug 09, 2009 4:39 pm ] |
| Post subject: | |
meeni wrote: make sure the oil pump drive is the same..
Note that Cooper S pin drive oil pumps are now NLA, and so are the spider (star) adaptors for Morris 1100S/Mini 1275LS to fit their splined shaft pump. I have steel laser cut adaptors in stock which will convert either type cam to take the 1275A+ slot drive pump. These pumps are the most commonly available now. See my thread (with pics) in the mods forum- http://www.ausmini.com/forums/viewtopic.php?t=39787 |
|
| Author: | TheMiniMan [ Sun Aug 09, 2009 4:46 pm ] |
| Post subject: | |
Hey kev,,, i think i will have to order a few of these adaptors from you (like maybe 10) ,,, i`m running out of spider cams & need to set up small bore cams into the Bimmer engines , by cutting all the lobes off them & fit those adaptors should do the trick & i can use the late slot drive pumps then i`ll bell you next week sometime if that`s ok? cheers |
|
| Author: | drmini in aust [ Sun Aug 09, 2009 4:53 pm ] |
| Post subject: | |
PM sent. 
|
|
| Author: | TheMiniMan [ Sun Aug 09, 2009 4:55 pm ] |
| Post subject: | |
PM recieved & Reply sent 10-4 big buddy
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|