ausmini
https://www.ausmini.com/forums/

Oil Filter Sandwich Plate
https://www.ausmini.com/forums/viewtopic.php?f=5&t=62313		 Page 1 of 1
Author:  albino235 [ Thu Apr 08, 2010 7:31 pm ]
Post subject:  Oil Filter Sandwich Plate
Hi,

I am trying to find a thermostatic oil filter sandwich plate for the spin on filter but I don't have one here to measure, so does anyone know the thread size/type and the O ring diameters for the spin on filter?
Or alternatively, has anyone bought one of these and can point me in the direction of a supplier?

Also, does anyone know the thread size/type of the banjo bolt fitting in the block that runs to the filter housing? I want to replace this with a flexible hose, so I just need to know what fittings I need to order.

Cheers,
Alex
Author:  drmini in aust [ Thu Apr 08, 2010 7:46 pm ]
Post subject: 
Can't help you on the filter sandwich plate.

The banjo bolt thread in the block though is 5/8-18 UNF.
Karcraft sells the proper fitting to go to 1/2 BSP oil hose (Cooper S etc).
Or, you can make them from a brass 1/2BSP x 3/8BSP brass nipple (Bunnings sell them cheap)= just machine the 3/8BSP end down to 0.625" diameter and run a 5/8 UNF die nut down it in a lathe. :wink:
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/