Quote:
I've fitted one of Ben's SC12 kits and I barely know which end of a screw driver to hold so if I can do it anyone can.
haha, well thats the boat I'm in so maybe I will be looking at supercharging also
| ausmini https://www.ausmini.com/forums/ |
|
| fitting a supercharger to my mini https://www.ausmini.com/forums/viewtopic.php?f=5&t=69105 |
Page 1 of 1 |
| Author: | min196 [ Sun Feb 27, 2011 7:05 pm ] |
| Post subject: | fitting a supercharger to my mini |
hi all, iv been thinking about fitting a supercharger to my mini and have came across to alot of people putting th sc12 with the h4 carb on it, my engine is a 1275 bored out to a 1310 with AP4 cam shaft? what would do you think about it ? would it have much power increase ? |
|
| Author: | Kennomini [ Sun Feb 27, 2011 9:33 pm ] |
| Post subject: | Re: fitting a supercharger to my mini |
min196 wrote: would it have much power increase ?
Yes. Exact amount is hard to say but I'd guess around 25% increase, but this is only a guess. Boost is always beneficial. |
|
| Author: | Irish Yobbo [ Tue Mar 01, 2011 8:38 am ] |
| Post subject: | |
Power increase? Yes, I suppose so. Torque increase? You'd better believe it... Supercharging increases the power but makes the car much more drivable, too. You (usually) get plenty of low-down torque. If you want stacks of power at high revs, go for a turbocharger. |
|
| Author: | swervedriver [ Thu Mar 10, 2011 11:39 pm ] |
| Post subject: | |
this may be a future endeavour for me also Is this a mod one could do on their own with (quite) Limited mechanical knowledge or is it something A mechanic would need to fit for me? I figure i'd need to get it tuned afterwards. |
|
| Author: | 69elf [ Fri Mar 11, 2011 6:50 pm ] |
| Post subject: | |
I've fitted one of Ben's SC12 kits and I barely know which end of a screw driver to hold so if I can do it anyone can. |
|
| Author: | shaanb [ Thu Mar 24, 2011 11:19 am ] |
| Post subject: | |
Quote: I've fitted one of Ben's SC12 kits and I barely know which end of a screw driver to hold so if I can do it anyone can.
haha, well thats the boat I'm in so maybe I will be looking at supercharging also
|
|
| Author: | Super-mini [ Thu Mar 24, 2011 12:44 pm ] |
| Post subject: | |
theres plenty of threads already detailing the sc-12 kits, but i would recommend having it fitted by a mechanic if you are not confident. it will need dizzy recurving and needle grinding so its a must to have it tuned properly. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|