Hi all, can you still buy liners for 1275's ? Idont need any just wondering if there out there, if so what would one expect to pay for them? With all the over bored motors out there i spose someone will want some oneday .[/img]

You must be able to, I had to have a cylinder re-sleeved after rust ate a hole in the cylinder wall.

Tim

Who got them ,your engine reconditioner? What state you in?

Russell Engineering in Sydney gets them from somewhere, he can sleeve a 1380 back to 1275. Not cheap to do though...

_________________
DrMini- 1970 wasaMatic 1360, Mk1S crank, 86.6HP (ATW) =~125 @ crank, 45 Dellorto (38 chokes), RE282 sprint cam, 1.5 rockers, 11.0:1 C/R.

Works out to be about $240 per cylinder
Cheers Pete

_________________
A recent study found the average Aussie walks about 900 miles a year
Another study found Aussies drink, on average, 22 gallons of alcohol a year
That means, on average, Australians get about 41 miles per gallon

Kind of makes you proud to be an AUSSIE

You can...but I think all the genuine Cooper S ones are long gone

_________________
"Show me the Mini!"

I'm building an S motor for a mate that just had 2 sleeves fitted, and then block bored to +.030", all by CB Performance in Seven Hills. Pistons are Hypatecs.
Looks a neat job, not sure what cost was, but I bet nothing like $240 per hole for the sleeve job..

_________________
DrMini- 1970 wasaMatic 1360, Mk1S crank, 86.6HP (ATW) =~125 @ crank, 45 Dellorto (38 chokes), RE282 sprint cam, 1.5 rockers, 11.0:1 C/R.

That was GR's price when I called him about 6 months ago.
Cheers Pete

_________________
A recent study found the average Aussie walks about 900 miles a year
Another study found Aussies drink, on average, 22 gallons of alcohol a year
That means, on average, Australians get about 41 miles per gallon

Kind of makes you proud to be an AUSSIE

Yep and Tasmania.
Expensive though, glad it was only one cylinder.

Tim