| ausmini https://www.ausmini.com/forums/ |
|
| Edis Module at U Pull It Elizabeth https://www.ausmini.com/forums/viewtopic.php?f=5&t=79117 |
Page 1 of 1 |
| Author: | woodwormm [ Wed Nov 07, 2012 3:52 pm ] |
| Post subject: | Edis Module at U Pull It Elizabeth |
anyone in the need ... there's a white auto mondeo at Upullit Elizabeth... I was there this morning and it still had its EDIS module on it.. looked quite fresh actually.. i took the air induction pipe off seeing if i could get the module, but alas the smallest i had was 10mm.. i'd say you need an 8mm socket or spanner... good luck |
|
| Author: | swiftden [ Wed Nov 07, 2012 8:09 pm ] |
| Post subject: | |
I need one for my future twinky project but too far for me to travel. what do they sell for ? |
|
| Author: | woodwormm [ Thu Nov 08, 2012 2:19 pm ] |
| Post subject: | |
I wasnt planning on paying for it... i reckon it'd fit in my baggy short pockets... I was already paying for a wheel for my trailer anyways... and surely the $2 entry fee really means it's all you can smuggle for 2 bucks? |
|
| Author: | kirby [ Thu Nov 08, 2012 6:43 pm ] |
| Post subject: | |
Most people dont run edis anymore and just drive one coil per cylinder directly. |
|
| Author: | Kennomini [ Thu Nov 08, 2012 8:10 pm ] |
| Post subject: | |
Yeah you can get coil top igniters from Toyota Yaris's and Sorers I believe. Fit almost flush in-between the twin cam cover ion the twinki heads, much neater. |
|
| Author: | kirby [ Wed Nov 14, 2012 9:39 pm ] |
| Post subject: | |
thanks for that, I was looking at the Ford v8 coils but finding dimensions was tricky. now I know what to look for on my twink i |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|