| ausmini https://www.ausmini.com/forums/ |
|
| engine machining in SE QLD https://www.ausmini.com/forums/viewtopic.php?f=5&t=81621 |
Page 1 of 1 |
| Author: | Kennomini [ Wed May 29, 2013 5:53 pm ] |
| Post subject: | engine machining in SE QLD |
Dose anyone know of a good engine machinist in SE QLD? I'm based on the Sunny coast so I don't really want to send it away to someone 1000km away. I need a 1275 block (just under 1360) bored/re-honed to suit my new +0.094 thou pistons. I also need the crank journals machined and balance everything from the harmonic balancer to the clutch. Any suggestions? I have already been given Chilton Engineering's (in Woolloongabba) contact details but have not yet been able to make contact. |
|
| Author: | MrFail [ Wed May 29, 2013 6:38 pm ] |
| Post subject: | |
My mate used to work at Mendham engineering in rocklea. They used to do some pretty cool work when he was there . Like balancing new V12 Lambo race boat cranks. Worth a crazy amount. |
|
| Author: | Wombat [ Wed May 29, 2013 6:47 pm ] |
| Post subject: | |
Sorry the mob I used have gone belly up |
|
| Author: | Mokesta [ Wed May 29, 2013 7:07 pm ] |
| Post subject: | |
My mate runs a business working on cars and he sends all engine machining work to Chilterns. M |
|
| Author: | Rob M [ Wed May 29, 2013 7:32 pm ] |
| Post subject: | |
ive got a mate that owns a shop called PEACH at Stafford, they have my motor there at the moment, his best mate works at Mendham so might be worth a call |
|
| Author: | TheMiniMan [ Wed May 29, 2013 7:45 pm ] |
| Post subject: | |
we use a number of people/companies to do various engine reco machining for us,,, 2 of these would be Wynnum engine reconditioning & the other is Cooparoo Engine reco both very good & we have trained them over the years with what we need them to do for our mini engines 
|
|
| Author: | dodge [ Wed May 29, 2013 8:49 pm ] |
| Post subject: | |
i will second terry at coorporoo engines in bulimba hes a no bull man or repco at coulandra |
|
| Author: | low n blown [ Thu Jun 13, 2013 9:12 am ] |
| Post subject: | |
Chilton Engineering Deshon St Woolloongabba. He is a mini enthusiast. Wouldn't trust anyone else. Didn't need any teaching. |
|
| Author: | Moke2b [ Sat Aug 03, 2013 7:09 pm ] |
| Post subject: | |
Probably a bit late, but these guys are at brendale and have some wiz bang CNC thingys, Can do the lot - have a good rep too. http://www.plr.com.au/ |
|
| Author: | 1275LS [ Sat Aug 03, 2013 10:25 pm ] |
| Post subject: | |
Moke2b wrote: Probably a bit late, but these guys are at brendale and have some wiz bang CNC thingys, Can do the lot - have a good rep too.
http://www.plr.com.au/ These guys just did my head. Came back looking pretty neat. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|