| ausmini https://www.ausmini.com/forums/ |
|
| twinky head gasket https://www.ausmini.com/forums/viewtopic.php?f=5&t=86665 |
Page 1 of 1 |
| Author: | austin7 [ Sun Jul 27, 2014 6:06 pm ] |
| Post subject: | twinky head gasket |
I am about to buy a k100lt head from the UK and was wondering if I should also purchase a BMW head gasket? I have been searching the forums about using this gasket, but have not come to any conclusions. Any advise would be much appreciated. |
|
| Author: | Kennomini [ Sun Jul 27, 2014 6:41 pm ] |
| Post subject: | Re: twinky head gasket |
There was a run of gaskets made her in Aus but I don't know if any are left. I got mine from Matt Reid, contact him on here or at his business in Brissy. |
|
| Author: | austin7 [ Sun Jul 27, 2014 7:16 pm ] |
| Post subject: | Re: twinky head gasket |
Thanks for reply. I am in nz, but I could try to get hold of Matt. I am going to order the head in next couple of days so I just need to confirm that the standard BMW head gasket is no good. |
|
| Author: | Kennomini [ Sun Jul 27, 2014 7:53 pm ] |
| Post subject: | Re: twinky head gasket |
That's correct the BMW gasket will not work. You can modify a std mini gasket but I'd prefer to use one made for the job. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|