Hey again, been having a busy weekend on the mini, thanks for the help so far. next up i am looking at replacing the printed circuit on the back of the gauges, i have pulled it out but it doesnt seem to match any of the ones on minisport. could someone please help identify which one i have and/or which one i need.

the one i have

the front so you know which gauges i have (its upside down to keep the gauges on the correct side)

the minisport one that is closest one i could find
http://www.minisport.com.au/prod1794.htm

it seems to be about 80% right except for the bit on the left around the tacho. any help would be much appreciated.

I now also have these correct Printed circuits for these Clusters which are also used on Clubman GT.. PM sent.

_________________
DID I MENTION THAT I AM THE BEST SUPPLIER FOR MINI ELECTRICAL PARTS AND REPAIRS?
"Let us remove your "SHORTS"

The PCB looks to be in good condition...why change it???

_________________
"Show me the Mini!"

It's hard to see in the photo but the section between the tachometer and fuel/temp gauges ( top left in photo ) has been bent to many times and has broken the connections

Ohh? OK....but you can just gently remove the conformal coating and solder (using say some multi=strand braid or wire) then spray or paint with a protective coating

_________________
"Show me the Mini!"