Can I please get somone to measure something on a rod change setup for me?
I need a measuremenent from the pivot point of the gear lever (nominal centreline) to the front of the internal crossmember (the face where the seat mounts go).

If I take a stab in the dark I'd be guessing it somewhere in the 5-6 inches range.

Thanks.

A template from a rod change car would be the best way???

You're trying to work out where to put the holes for the cotton reel mounts?

_________________

Not far off.
My deluxe had remote mounting and I'm going the rod.
My holes may be a fraction out from normal because my engine sits tilted forward a bit, but just for playing round at the moment I'm after its mounting location.

Measuring to the stick is better for me as I don't know how I'll make the bracket to hold it yet (exhaust seems to hit).

I've got a few with rod changes here you could measure/take a template from, come round and have a look if you like.

Andrew