Im looking at putting my motor back in tomorrow "but" Have just noticed that their is a ball bearing missing where the drive flanges come out next to the diff (in the box not the drive shafts). To get at these I need to take the side plate of and the diff housing, only problem is I dont have a gasket to replace it with and all the shops are shut until tuesday I believe. If you have these gaskets would I possibly be able to take them off your hands and replace next week?

Any help muchly appreciated!

ring steve from brickworx,he is notmaly in and out of his workshop on weekends!

_________________
BRICKWORX RACING
872-874 South Rd
Edwardstown
SA 5039
PH: 8297 9494
FAX: 8297 7133

Its called... a manilla folder and gasket goo

OR

silastic/silicone

Yeah, Kazjim taught me that trick.

Weetbix box + razor + spray on goo = thermostat + the tap thing gaskets.

_________________
No more Minis!......For now.

If you haven't got the gaskets yet, phone me on 0408599619. I am 99% certain I have a complete gasket set for a 1275 in the shed. If the ones you want are interchangable you can replace them later. Only problem is that I am 10 minutes past Brickworx so it's a bit of a drive from your place. Good news is that you can bring the extractors I won on Ebay and I can pay you for them and you can bring the other stuff so I can have a look and see whether they are worth the slabs of coke or not )

smithy

couldnt you just buy some gasket paper? and then make your own...

all you need is a roundnose hammer and a sheet of gasket paper
check your local hardware store.

or just use willy's method same thing really

cheers

_________________

I think I will wait until a mini place opens. Dont want to have to pull it apart again on account of a couple of gaskets. Should still be able to have it running by tuesday, then back to kaniva, and register it the following week when Im back in adelaide.