Guys,

Need info about engineer's for the conversion. When i started i rang an engineer and spoke to him about what i wanted to do and he confirmed it was OK he also gave me fixed prices of $100/ hr and $350 for final certificate. Anyway to cut a long story he seems to have fallen of the edge of the world, phone does not work and no new listing in the phone book.

Anyway i started ringing around and got one guy telling me $1500 (seemed to pluck the no out of thin air) and another guy was almost as bad a Matt's inspector (probably related to the act inspector) need a cat convertor, collapsable column etc etc.

So who has used what engineer and how much has it cost??

I am at the stage wher i want to strip the engine bay out to respray and clean the motor and re-assemble.

Dan

Dan I think I must have given you the wrong idea about my engineer, he actually said I didn't need a cat and basically didn't really tie me down to much really. As engineers go he was pretty open minded...I'd recommend him...

Actually I just reread your post the above doesn't make alot of sense sorry...

Cheers

Matt

_________________
225hp atw on 14psi. 1/4 Mile no idea. Take one 1971 Mini Clubman, one Starlet GT Halfcut, Simmer over a warm MIG Welder, and Voila Minstar! www.mpdesign.id.au

I can get you two names...

I'll call you this arvo... If you havent heard from me by dinner give me a buzz..

Cheers

_________________
Baracade
Relationships! The only time you get to sleep with the enemy!
1972 US Export Moke in Bundaberg QLD

Dean,

Can you Pm me your No and I'll give you a buzz tomorrow.

Thanks

Dan