Ausmini
It is currently Mon Jul 28, 2025 2:45 am

Board index » Mini Chat » Mini Chat

All times are UTC + 10 hours




Post new topic Reply to topic  Page 2 of 3
  [ 38 posts ]  Go to page Previous  1, 2, 3  Next
  Print view Previous topic | Next topic 
Author Message
Lillee
 Post subject:
PostPosted: Wed Nov 01, 2006 3:36 pm 
Offline
1360cc
1360cc
User avatar

Joined: Tue Jun 01, 2004 3:41 pm
Posts: 6858
Location: Special Tuning Sydney
Oooo my favourite topic!

Castrol Edge 25W50 (formerly known as Formula R). It's the best stuff...

HPR is too thick for a new engine, I wouldn't bother until you have 100,000 miles on the clock and she's smoking/leaking oil.

I will be running Castrol.

For running in I run what Graham Russell swears by which is KMart's own KMX. At $14 for 6L it's a bargain buy. He uses it to run in all sorts of engines and has had no problems with it (that $50,000 Ford BDA motor included). It has a "Turbo Car" rating on the bottle and for any oil to have this it has to pass stringeant tests.

What Kmart does is it buys up the remaining reserves from big companies and puts in it's own additives (not friction modified) and the overall end product is very good.

I will most likely run KMX for the first few thousand miles. The stuff aint bad I must admit...

_________________
Lillee - 1969 Morris Mini K
Top
 Profile  
 
czerial
 Post subject:
PostPosted: Wed Nov 01, 2006 3:39 pm 
Offline
1275cc
1275cc
User avatar

Joined: Fri Oct 15, 2004 2:46 pm
Posts: 5281
i agree on castrol. i like it very much
Top
 Profile  
 
Lillee
 Post subject:
PostPosted: Wed Nov 01, 2006 3:41 pm 
Offline
1360cc
1360cc
User avatar

Joined: Tue Jun 01, 2004 3:41 pm
Posts: 6858
Location: Special Tuning Sydney
Castrol is the best. It even smells good!!! :oops: :oops: :wink:

_________________
Lillee - 1969 Morris Mini K
Top
 Profile  
 
czerial
 Post subject:
PostPosted: Wed Nov 01, 2006 3:43 pm 
Offline
1275cc
1275cc
User avatar

Joined: Fri Oct 15, 2004 2:46 pm
Posts: 5281
doesnt taste bad either! :shock:
Top
 Profile  
 
drmini in aust
 Post subject:
PostPosted: Wed Nov 01, 2006 4:51 pm 
Offline
religious status
religious status
User avatar

Joined: Fri Mar 19, 2004 6:19 pm
Posts: 39757
Location: near Baulkham Hills, NSW
pristic wrote:
Yes, GR recommends KMX. (K-Marts 'own' label but with good stuff inside)

Wasabipimninja, you said everything is new in this motor, right? Who built it? You or a shop?? get what the shop recommends if it was...

Peter.

He uses KMX (it's made by Shell) for running in and power runs on the dyno, not sure what's in his road car- but he recommends Castrol 25W/50 (Formula R / Edge) for track use. :wink:

_________________
DrMini- 1970 wasaMatic 1360, Mk1S crank, 86.6HP (ATW) =~125 @ crank, 45 Dellorto (38 chokes), RE282 sprint cam, 1.5 rockers, 11.0:1 C/R. :mrgreen:
Top
 Profile  
 
GT
 Post subject:
PostPosted: Wed Nov 01, 2006 6:50 pm 
Offline
1098cc
1098cc

Joined: Thu Aug 17, 2006 10:23 am
Posts: 1621
I ran a Franklins brand 20/50W oil in a mini for a year. It was quite good and only $11 for 5L. Nice gear changes. No burning at all. Oils IS oils IMHO......:mrgreen:
Top
 Profile  
 
LS1380
 Post subject: Re: Oils aint Oils...
PostPosted: Wed Nov 01, 2006 9:14 pm 
Offline
Moke + Wife = out of the doghouse
User avatar

Joined: Thu Aug 18, 2005 11:41 pm
Posts: 2645
Location: Perth-Western Australia
WasabiPimpNinja wrote:
So my new engine is built and ready bar a few bits and pieces down at the chromers. Everything in it is new and now comes the big decision, Which oil to use?

I was thinking being an older engine something in the 20w-50 range would be best. I'm not going to run my oil cooler (unless I find out I need to), and I wont be revving it too hard untill I get hold of a set of worthy rockers.

Just looking for some opinions of what types of oils and what weights people use. Synthetic or not etc.

Cos as we all know, Oils aint oils.

I and others use this :D
Street or closed events.
Image

_________________
_______________________________________________________________________________
Image
Top
 Profile  
 
WasabiPimpNinja
 Post subject:
PostPosted: Thu Nov 02, 2006 7:27 am 
Offline
848cc
848cc
User avatar

Joined: Mon Aug 07, 2006 2:15 pm
Posts: 425
Location: Perth, WA
Good stuff. Sorry about this topic being covered before, wasn't really thinking when I posted.

Thanks for all the info, I've had a read through the other stuff as well now.

I also had a long chat with the guy who built my engine about this topic as well, and he has recommended Penzoil 25w 50 (what he runs in his Mini).

LS1380: That's a pretty speccy looking drum of oil :P What's that worth a drum? Do you have to buy it from the depot?

_________________
-Wasabi
1972 Clubman - Daily Driver
1962 850 - EW1 Powered
Top
 Profile  
 
LS1380
 Post subject:
PostPosted: Thu Nov 02, 2006 8:13 am 
Offline
Moke + Wife = out of the doghouse
User avatar

Joined: Thu Aug 18, 2005 11:41 pm
Posts: 2645
Location: Perth-Western Australia
Buy in drum for about $130 or 5L plastic container from servo.

_________________
_______________________________________________________________________________
Image
Top
 Profile  
 
Matt68
 Post subject:
PostPosted: Thu Nov 02, 2006 8:49 am 
Offline
1275cc
1275cc
User avatar

Joined: Thu Mar 18, 2004 1:33 pm
Posts: 2213
Location: Darling Downs QLD
For running in opil I have been recommended to use the castrol HPR30.

Remember, to a lot of folk cheap oil is good cos it saves them a penny or two, but the real test of wether an oil is any good is how much it protects your engine from wear. With that in mind, the only way to know for sure would be to test various engines of the same type under the same load for 100000 k's or so, then check for wear.

If you haven't run your motor on a cheap ass oil for 100000+ k's then had it dismantled and inspected for wear, you cannot comment that it is 'just as good' as a dearer oil, and vice versa.

However, for the extra piece of mind, and the knowledge that I KNOW what is going into the motor, i will continue to use Castrol Edge.

Recommended to me by countless mechanics who specialise in minis, who drive minis, who race minis.

Cheers
Matt

(PS Bad headache, me grouchy!) :wink: :lol: :lol:

_________________
68 Deluxe.... it's shiny..... I like shiny!!
Top
 Profile  
 
Mini Mad
 Post subject:
PostPosted: Thu Nov 02, 2006 10:09 am 
Offline
ET 13.457 seconds , OH YEAH !!!!
User avatar

Joined: Sun Sep 19, 2004 8:35 am
Posts: 7826
Location: Somewhere Around Sydney
speedy wrote:
I thought GR used KMX oil not just for running in.

I'd recommend Castrol edge (the one for big bore engines), I've used Valvoline and noticed a significant improvement (especially with the gear change) with Castrol.

As GT said, do a search on "Oil", there is over an hour's worth of reading material on topic.


Agreed, XLD makes gear changes crap!

Haha you really need the 'big bore' stuff don't ya :P

_________________
Image
Starlet Conversion:
http://www.ausmini.com/forums/viewtopic.php?t=15484
Top
 Profile  
 
Lillee
 Post subject:
PostPosted: Thu Nov 02, 2006 10:26 am 
Offline
1360cc
1360cc
User avatar

Joined: Tue Jun 01, 2004 3:41 pm
Posts: 6858
Location: Special Tuning Sydney
KMX oil is not bad at all. If you have to use a cheap oil for budget purposes, you can't go past this oil for $14 for 6L...

I got 8 bottles of formula R 25W50 before it went to Edge for about $27 a bottle so I can't complain. That's roughly 2 years worth :wink:

_________________
Lillee - 1969 Morris Mini K
Top
 Profile  
 
speedy
 Post subject:
PostPosted: Thu Nov 02, 2006 8:23 pm 
Offline
Slow-Po
User avatar

Joined: Fri Jul 08, 2005 8:56 pm
Posts: 9979
Mini Mad wrote:
Haha you really need the 'big bore' stuff don't ya :P


You're a nasty piece of work. :x :P :lol:

_________________
One should never skimp on the zip ties.

Image
Top
 Profile  
 
Minimad
 Post subject:
PostPosted: Fri Nov 03, 2006 12:29 am 
Offline
848cc
848cc
User avatar

Joined: Fri May 21, 2004 2:47 pm
Posts: 440
Location: Brisbane, QLD Ausie
Lillee wrote:
KMX oil is not bad at all. If you have to use a cheap oil for budget purposes, you can't go past this oil for $14 for 6L...

I got 8 bottles of formula R 25W50 before it went to Edge for about $27 a bottle so I can't complain. That's roughly 2 years worth :wink:


Other than being on sale as a sell out...."Why???"

There is no difference in the old castrol formula R and the new Edge other than the packaging!!

Minimad

_________________
You can take the boy out of the racer.........but not the racer out of the boy!
Top
 Profile  
 
Lillee
 Post subject:
PostPosted: Fri Nov 03, 2006 7:46 am 
Offline
1360cc
1360cc
User avatar

Joined: Tue Jun 01, 2004 3:41 pm
Posts: 6858
Location: Special Tuning Sydney
i know that! that's why i bought 8 bottles! $27 a bottle vs $38 a bottle 1 week later, different name, same stuff!

I doubt Edge will ever be about $27 ever, not esp now that they have to pay for their million $ ad campain :lol:

_________________
Lillee - 1969 Morris Mini K
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 2 of 3
  [ 38 posts ]  Go to page Previous  1, 2, 3  Next

Board index » Mini Chat » Mini Chat

All times are UTC + 10 hours


Who is online

Users browsing this forum: No registered users and 103 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  

© 2016 Ausmini. All garage work involves equal measures of enthusiasm, ingenuity and a fair degree of irresponsibility.