that fasten the piano hinge on the rear side windows?

i vaguely recall them being countersunk philips, but not sure of size, or if they are set screws or self tappers.....

and, i have no idea where i have put mine.

cheers
michael

_________________
the world is a book, and those who do not travel read only a page
66 Mini Minor sponsored by http://www.lifeonthehedge.com.au/ The Dog Harness Specialists
It was a pleasure ausmini. I'll miss all you misfits and reprobates

Chrome plated, Phillips Head counter sunk self tappers. 6 guage x 1/2"

_________________
Curly
'64 Cooper 'S' (Group Nb spec)
'67 Mini Marcos GT www.mm7056.wordpress.com

cheers curly

_________________
the world is a book, and those who do not travel read only a page
66 Mini Minor sponsored by http://www.lifeonthehedge.com.au/ The Dog Harness Specialists
It was a pleasure ausmini. I'll miss all you misfits and reprobates

Watch it there are 2 thread pitches in 6 gauge, #6x32 and #6x40. Not sure which these are.. best to find a sample and take it.

_________________
DrMini- 1970 wasaMatic 1360, Mk1S crank, 86.6HP (ATW) =~125 @ crank, 45 Dellorto (38 chokes), RE282 sprint cam, 1.5 rockers, 11.0:1 C/R.

Does it really matter which thread pitch? As its only going through the 1 layer of sheet steel no?

I had the same problem, I use a little bigger ones that mentioned above. I couldnt really get them to bite that much so I countersunk it a bit more and use some bigger SS ones.

_________________