Does anyone else have a problem with Ben's SC12 kit obstructing the speedo cable at the speedo end? It's a bit annoying having no speedo .

ya dont need a speedo to tell how fast your going a tacho, oil pressure and a rope will suffice

_________________
Here am I sitting in my tin can far above the Moon
Planet Earth is blue and there's nothing I can do...



“A turbo: exhaust gasses go into the turbocharger and spin it, witchcraft happens and you go faster.” - Jeremy Clarkson

The cable should run under the carby to SC manifold without too many hassles. Will be a pain to fit with the manifold on though.

_________________
4efte powered Clubman
supercharged 998 race car

no speedo cable for me - used a bike speedo off the rear hub, (this is mainly because i forgot to change the drive and my mini cable won't fit the metro box)

_________________
backyard performance............. Aint it the best

I use a GPS, the speed reading on that is better than a speedo..... And I don't get lost!

Also, speedo is not hooked up......

thats where mine goes on the sc kit was a challenge to get it on but it made it

_________________
Enjoy Chris

hehe thread the needle

you'll need a speedo with all that boost

My SC12 was into an 850, and can honestly say I had absolutely no issue fitting the speedo cable past the blower...

_________________
Carl
Previous Owner & Driver of 1 Morris "It's not a Cooper!!" 850

I didn't have any issues with my speedo, just pushes under my carby and down and it.

I will say though that the cable was attached when the engine was put in last.

_________________
1964 Morris 850, 1330 Supercharged - 81.8hp atws.
1975 Leyland Mini S 1100S powered - Nice and reliable.
1977 Leyland Mini LS - Project LS-T