If you have bought Hi Lo's from Minisport in the UK: they come with a black plastic cap on the end of the cone. Do I take this off or fit the hi lo with it?

It fits with or without it in!

_________________
Regards,

Mike
"He who dies with the most toys wins."

pic? can't see the rubber cone mounting face of the hilo in the picture of them on the website



you're not talking about this bit are you? if so, then yes, the cup stays on there - it's called a knuckle

1/2 fill the cones with some good grease too stops corrosion over time

_________________
A good friend will come and bail you out of jail...but a true friend will be sitting next to you saying "Damn...that was fun!"

Leave 'em on... They help to keep the threads from rusting up...

It's not the knuckle I'm talking about - it's the other end that you can't see in the picture.

Consensus seems to be leave them in as they help prevent water getting into the cone thereby preventing corrosion. Plus, grease absolutely everything!

Thanks...

_________________
Regards,

Mike
"He who dies with the most toys wins."

For the record....Minisport say leave em on.

Big night of greasing-up ahead - and then I might work on the subframe

_________________
Regards,

Mike
"He who dies with the most toys wins."