hi lads

are there any type of shims or anything like that to line these doors up?

my drivers side only wont shut, i need to slam the hell of out it to get it nearly shut & it jams, i found some shim looking things from them originally though but this is a new door.

Make them out of a coke can, you can cut them out with scissors and they wont go rusty. One can thickness on the lower hinge = about 5-6 mm at the back end. Hope this is helpful.

peter that is a freaking great idea you are the man will try this tomorrow.

You can make shims out of Coke cans, Milo tins and plastic drink bottles depending on the purpose.

Is the hinge old? They're crap and wear out like aussie ones, so check that too.

not worn.. it's not sitting right though to high.

i wonder if i can buy them hinge shims locally though? anyidea harley?

My idea is to man up, get some scissors and a coke can like the otehrs said and make some shims.
Hint: if you slot one side you don't need to remove the hinge bolts completely to slide the shim in and out when adjusting.

hehe yeh i was thinking would be better having some steel shims.

ill make some up tomorrow.