Doc or Miniman probably know this straight up but what's the correct length bolt going into the engine block through the steady bar bushes.

Same size as the one through the master cylinder bracket?

Che cheers

_________________
PrOuDlY aSkInG qUeStIoNs FoR uR aMuEsMeNt

I'm neither of those guys but the bolt is 2" long. Same for the one under the M/Cs. The one for the block maybe 1 3/4" if you don't have the bracket with the solenoid there.

_________________

thanks gt .

I did remove sol bracket & used the original bolt.

Should be alright largish washer in there & the mattys bushes don't compress much.

_________________
PrOuDlY aSkInG qUeStIoNs FoR uR aMuEsMeNt

I just measured the original bolt, it is 1-7/8" long. But a 2" would work.
This is with the 1970 solenoid bracket setup behind the steady bar, against the block.

_________________
DrMini- 1970 wasaMatic 1360, Mk1S crank, 86.6HP (ATW) =~125 @ crank, 45 Dellorto (38 chokes), RE282 sprint cam, 1.5 rockers, 11.0:1 C/R.