Looking for DLI certified welder in or near the blue mountains for a job on my project.

I have narrowed the rear of a box section type chassis by by putting a pie cut on the inner rail and bending it in, and on an outer rail and bending it out. I intend to have this welded up and fish plated (i will cut the plates)

My Engineer has said it has to be welded a DLI certified welder. I have the welder and whatnot, 250 amp MIG, just need someone to point it.

Flick me a PM if your keen to make a bit of cash on the side

_________________
--Insert legal disclaimer here--