Greetings All.

I'm about to spray the inner boot on my project. Found, cleaned and primed the boot board brackets. The center one is missing a bit. (refer pic)
Looking at a parts site, I seem to be missing a support part. Looking at the rivet holes in the boot floor, I guess it matches the two side brackets but is shorter. This I can make. Does it have a right-angle at the top to sit under the rubber latch?

Does anyone have a picture of how it looks, or sits?



Thanks
Alex.



[/img]

http://www.minispares.com/product/Classic/Body/Boot/Fittings_seals/14A9782.aspx?030302

Does this help....

Thanks for the pic. I did find a couple pic,s latter last night, but couldn't see how it joined together. I ended up folding up my own "upright", and brazed it where it touched.
Thanks again.
Cheers
Alex.