Hi
Just a quick question, i am about to fit the front wheel bearings, the ones i have seem to have a small centre piece the protrudes out… does this piece face into the hub or out?
Cheers

These are the bearings

They're the integral spacers. They face inwards.

_________________
SooperDooperMiniCooperExpertEngineering

All garage work involves equal measures of enthusiasm, ingenuity and a fair degree of irresponsibility.

thanks for that
what about the white plastic washer/seal…. is that on the inside or outside bearing set?
regards

I can't see the image, but is it a stand off spacer for the seal? In that case it may replace the inside seal to stand it out a little further from the bearing. In original setups, there wasa steel band to hold the inner seal about a quarter inch or so away from the inner bearing.

_________________
SooperDooperMiniCooperExpertEngineering

All garage work involves equal measures of enthusiasm, ingenuity and a fair degree of irresponsibility.

white plastic piece will actually slide onto the cv joint and protects the inner seal.

ok so on the CV joint side, and against the CV joint?
Cheers

your picture doesn't appear visible ( well at least to me and Mick


if you re post using photbocket or similar i am sure exact answers will ensue

yeah i did use photo bucket… and not sure what happened!
copy URL and paste