crumpet wrote:
womble99 wrote:
MrFail wrote:
My old boss had a really nice one for his mx5 race car. It had an airbag setup on it so the tray part could be lowered almost flat between the wheel arches so that you could get really low cars on.
I'd hate to see what it cost him but
Sounds like the tandem from tilta, I can get the base model of that delivered down here with no extra for just under $7500

(think i would rather get another mini)
Unless you are carrying other much bigger cars a single axle for a mini is fine mate, much lighter, easy to move around, $2500-$4500 will get you a good one, just check those measurements to be safe than sorry remember you car might be a different height to other minis

I have been asking for a generic height for the door as I will have more than just the one mini to move so I figured there was no real point in making sure it was exactly to the dimension of my current mini (which isn't here at the moment) but so far no one has offered an actual measurement. I am pretty sure I won't be getting the deluxe airbag model just to move my mini's, though it would be nice I am absolutely positive I won't be able to convince SWMBO that it is a required purchase.
So far my research is making me lean towards a custom made tilt trailer with a hydraulic assist which is a combination from a few trailer I have seen so far which I will discuss with my local engineer. Being in Adelaide seems to add a motza to the cost of anything from interstate so local built seem to be the best option for now but I will keep looking.