ausmini • View topic - honda caliper mounting Brackets

Board index » Mini Chat » Mini & A/A+ Series Mods

All times are UTC + 10 hours

honda caliper mounting Brackets

Moderators: winabbey, simon k, poeee, Mick

Page 1 of 1

[ 3 posts ]

Print view

Previous topic | Next topic

Author

Message

chasg

Post subject: honda caliper mounting Brackets

Posted: Wed May 25, 2005 8:48 pm

848cc

Joined: Sun Nov 14, 2004 6:13 pm
Posts: 178
Location: brisbane

Can you make the caliper mounting brackets out of 10mm thick mild steel ?
The drawing l have says 8mm thick steel. The reason l am asking is because l may be able to get some sets made as a training exercise for the students at the Tafe where l work and they only have 6mm or 10mm thick mild steel

Top

Post subject:

Posted: Wed May 25, 2005 9:01 pm

1275cc

Joined: Wed Jan 19, 2005 1:52 pm
Posts: 2582
Location: Brisbane

buy some 8mm? nah use 6mm and use 2mm washers. easy

Top

drmini in aust

Post subject:

Posted: Wed May 25, 2005 9:27 pm

religious status

Joined: Fri Mar 19, 2004 6:19 pm
Posts: 39754
Location: near Baulkham Hills, NSW

Yes you can get 8mm. I bought 130x8 flat bar from Bohler Steel. :wink:

Actually 8mm is a bit thick- the ones I did for kazjim I had to mill back to 7mm, where the caliper bolts on.

_________________
DrMini- 1970 wasaMatic 1360, Mk1S crank, 86.6HP (ATW) =~125 @ crank, 45 Dellorto (38 chokes), RE282 sprint cam, 1.5 rockers, 11.0:1 C/R. :mrgreen:

Top

Page 1 of 1

[ 3 posts ]

Board index » Mini Chat » Mini & A/A+ Series Mods

All times are UTC + 10 hours

Who is online

Users browsing this forum: No registered users and 10 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: