can anyone tell me if the size of the balls in clubman inner pot joints changed sizes in later models or is there a diference when going from imp sizes to metric. the replacement balls that i got have caused me drama
Graham

21/32 is the size they are all supposed to be, i`ve not found any other sizes so far, but the race`s & cages differ in sizes for the reco ones, i`ve found 4x different sizes of those so far
beware

_________________
No offence intended here but--> anyone writing a book about minis 30 years ago may not have experienced such worn or stuffed-with components as we are finding these days.

You should put your heart & soul into everything you do.

Matt, where do you stand on fitting bigger balls in worn pot joints to make em niceandtite?

_________________
"Show me the Mini!"

sorted the problem the supplier got the balls mixed with metric and they ended up being 7th bigger than needed. they fitted my pot joint and went in with a slight bit of force but would not allow full movement without jamming. was lucky as on test run the shaft pulled out of cvjoint and started doing loops. ended up with a new pot joint today so all matches. one problem I got is that the hole in the sub frame is not big enough to allow inner pot joint to pass through so have to fit after shaft put through without joint on thanks for the help
graham
another thing are minis getting lower or am I just getting old