Hello people!

I'm going to use a rover handbrake setup in my deluxe, just wondering if I can get any rover owners to measure up the square bracket (the back one) that holds the handbrake ratchet up in the car?

I need its height off the tunnel, thickness, and width as a minimum.

Any help is greatly appreciated.

Thanks.

Hope this helps a bit
A = 25mm
B = 50mm
C = 40mm
It is 1.6mm thick and is set back 138mm from cross member to front of bracket.
Cheers Pete

_________________
A recent study found the average Aussie walks about 900 miles a year
Another study found Aussies drink, on average, 22 gallons of alcohol a year
That means, on average, Australians get about 41 miles per gallon

Kind of makes you proud to be an AUSSIE

Pete you are a legend!

Thankyou very much!

No worries
Cheers Pete

_________________
A recent study found the average Aussie walks about 900 miles a year
Another study found Aussies drink, on average, 22 gallons of alcohol a year
That means, on average, Australians get about 41 miles per gallon

Kind of makes you proud to be an AUSSIE

If it's not too much to ask, don't suppose you can tell me roughly where the hole for the cable to go through the floor is relative to the bracket?

I will have a look tomorrow when I get home from work .
Cheers Pete

Edit- Just went and measured it, from the bracket to the handbrake cable hole is 85mm.

_________________
A recent study found the average Aussie walks about 900 miles a year
Another study found Aussies drink, on average, 22 gallons of alcohol a year
That means, on average, Australians get about 41 miles per gallon

Kind of makes you proud to be an AUSSIE