when i get her back i'll have a look see.
get back to you .

_________________
PrOuDlY aSkInG qUeStIoNs FoR uR aMuEsMeNt

I think I got mine from Mini Mania in the US?

_________________

http://www.youtube.com/user/Hanras

They are 14mm thick so looks like the 24mm I thought was a bit small. So there is 28mm of filter thickness over the whole diameter.

_________________
"In two years time your car will be like a lady's clothes, out of date, my car will still be in fashion when I am dead" - Sir Alec speaking to Pininfarina

Righteo, thanks for that mate. Im about 2mm shy.... I think the bench grinder can fix that!!! Or Ill just trim the filter i bit to clear the stub stack.

_________________

http://www.youtube.com/user/Hanras

So are the bases you have the right diameter?

Keep in mind that if you are thinking that, these filters are meant to be wedged together between two plates, as shown in the full kit. I don't think you could just plug it in to your ramflow filter base & have it work.

_________________
"In two years time your car will be like a lady's clothes, out of date, my car will still be in fashion when I am dead" - Sir Alec speaking to Pininfarina

Yeah yeah, Ill end up buying the full kit as you have. But I need to be able to clear the stub stack. I was kind of assuming the bases would all be about the same size...?

_________________

http://www.youtube.com/user/Hanras

The inside edge of my base is a perfect fit around the air filter, no gaps etc. I'd compare your bases against the outside diameter of the air filter as listed on the K&N site, not from my original measurements. That should give you a pretty good idea.

_________________
"In two years time your car will be like a lady's clothes, out of date, my car will still be in fashion when I am dead" - Sir Alec speaking to Pininfarina